Ntp And Daylight Saving Time Parameters; Table 6-9: Ntp And Daylight Saving Time Parameters - AudioCodes MP-124 User Manual

SIP User's Manual
Parameter
6.1.9

NTP and Daylight Saving Time Parameters

The Network Time Protocol (NTP) and daylight saving time parameters are described in the
table below.
Parameter
NTP Parameters
Note: For detailed information on Network Time Protocol (NTP), refer to ''Simple Network Time
Protocol Support'' on page 453.
Web: NTP Server IP Address
EMS: Server IP Address
[NTPServerIP]
Web: NTP UTC Offset
EMS: UTC Offset
[NTPServerUTCOffset]
Web: NTP Update Interval
EMS: Update Interval
[NTPUpdateInterval]
Daylight Saving Time Parameters
Day Light Saving Time
[DayLightSavingTimeEnable]
Start Time
[DayLightSavingTimeStart]
End Time
[DayLightSavingTimeEnd]
Offset
[DayLightSavingTimeOffset]
Version 5.8
lease.
Note: For this parameter to take effect, a device reset is required.

Table 6-9: NTP and Daylight Saving Time Parameters

The IP address (in dotted-decimal notation) of the NTP server.
The default IP address is 0.0.0.0 (i.e., internal NTP client is
disabled).
Defines the Universal Time Coordinate (UTC) offset (in seconds)
from the NTP server.
The default offset is 0. The offset range is -43200 to 43200.
Defines the time interval (in seconds) that the NTP client requests
for a time update.
The default interval is 86400 (i.e., 24 hours). The range is 0 to
214783647.
Note: It is not recommend to set this parameter to beyond one
month (i.e., 2592000 seconds).
Determines whether to enable daylight saving time.
[0] Disable (default)
[1] Enable
Defines the date and time when daylight saving begins.
The format of the value is mo:dd:hh:mm (month, day, hour,
minutes).
Defines the date and time when daylight saving ends.
The format of the value is mo:dd:hh:mm (month, day, hour,
minutes).
Daylight saving time offset (in minutes).
The valid range is 0 to 120. The default is 60.
6. Configuration Parameters Reference
Description
Description
227 September 2009