AudioCodes MP-124 User Manual page 332

Parameter
IP to Hunt Group Routing Table
IP to Hunt Group Routing Table
[PSTNPrefix]
Web/EMS: IP to Tel Routing
Mode
[RouteModeIP2Tel]
SIP User's Manual
''Format of ini File Table Parameters'' on page 191.
This ini file table parameter configures the routing of IP calls to
Hunt Groups. The format of this parameter is as follows:
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_DestPrefix,
PstnPrefix_TrunkGroupId, PstnPrefix_SourcePrefix,
PstnPrefix_SourceAddress, PstnPrefix_ProfileId,
PstnPrefix_SrcIPGroupID, PstnPrefix_DestHostPrefix,
PstnPrefix_SrcHostPrefix;
[\PSTNPrefix]
For example:
PstnPrefix 0 = 100, 1, 200, *, 0, 2, , ;
PstnPrefix 1 = *, 2, *, , 1, 3, acl, joe;
Notes:
This parameter can include up to 24 indices.
For a description of these parameters, refer to the
corresponding Web parameters in ''Configuring the IP to
Trunk Group Routing Table'' on page
To support the In-Call Alternative Routing feature, you can
use two entries that support the same call, but assigned with
a different HuntGroup. The second entry functions as an
alternative selection if the first rule fails as a result of one of
the release reasons listed in the AltRouteCauseIP2Tel table.
Selection of Hunt Groups (for IP-to-Tel calls) is according to
destination number, source number,and source IP address.
The source IP address (SourceAddress) can include the 'x'
wildcard to represent single digits. For example: 10.8.8.xx
represents all IP addresses between 10.8.8.10 and
10.8.8.99.
The source IP address (SourceAddress) can include the
asterisk ('*') wildcard to represent any number between 0 and
255. For example, 10.8.8.* represents all addresses between
10.8.8.0 and 10.8.8.255.
If the source IP address (SourceAddress) includes an FQDN,
DNS resolution is performed according to DNSQueryType.
For available notations that represent multiple numbers, refer
to ''Dialing Plan Notation for Routing and Manipulation'' on
page 377.
For a description on using ini file table parameters, refer to
''Format of ini File Table Parameters'' on page 191.
Determines whether to route IP calls to the Hunt Group before or
after manipulation of destination number (configured in
''Configuring the Number Manipulation Tables'' on page 124).
[0] Route calls before manipulation = Calls are routed before
the number manipulation rules are applied (default).
[1] Route calls after manipulation = Calls are routed after the
number manipulation rules are applied.
332
MP-11x & MP-124
Description
135 .
Document #: LTRT-65412