Rep 3.0.14 System Stabilizer; Rep 3.0.18 Pick And Retard Rollers - Xerox Phaser 8860 Service Manual

REP 3.0.14 System Stabilizer

Parts List on PL 3.0
Removal
Remove the 2 screws that secure the System Stabilizer to the chassis.
Figure 1 Removing the System Stabilizer
Repairs and Adjustments
REP 3.0.14, REP 3.0.18

REP 3.0.18 Pick and Retard Rollers

Parts List on PL 3.0
Removal
The Pick Roller catch is located on the ceiling of the tray cavity about 1/4 of the way across the
unit from the right side, and about 5 in. (12.5 cm) back. When you pull forward on the catch, the
roller swings down.
1. Remove Tray 2.
2. Release the Pick Roller catch and pull downward to remove the roller.
Figure 1 Replacing the Pick Roller
3. Lift the Retard Roller to vertical, then pull the roller from the shaft in the tray. See
09/2007
4-48
Figure 2.
Initial Issue
Phaser 8860/8860MFP Service Manual