Xerox Phaser 8860 Service Manual page 180

5. Hold tension with one hand while removing the Y-Axis Belt with the other.
6. Remove the Y-Axis Spring using either a spring hook or pliers, Brace the printer to prevent
movement while removing the spring.
7. Disconnect the motor (P/J18) from the Electronics Module and remove the harness from
the cable guide.
8. Disconnect the Tray 1 Pick Solenoid (P/J241) from the harness.
9. Disconnect the Tray 2 Pick Clutch (P/J230) from the harness.
Figure 2 Y-Axis Assembly Electrical Connections
10. Release the harness from the retainers in the chassis.
Repairs and Adjustments
REP 4.0.11
NOTE: Observe the routing of the Y-Axis Motor harness. The harness exits the motor cav-
ity through the notch provided at the bottom of the mount.
11. Remove 3 (plastic, T-20) screws, and 2 (metal, T-20) screws with ground connections from
the Spring Arm and slide the assembly out of the chassis.
Figure 3 Removing the Y-Axis Drive Assembly
Replacement
When replacing the Y-Axis Drive screws, torque to no more than 12 in.-lbs. Overtightening
these fasteners can result in irreversible damage to the chassis.
Check that the grounding lugs are captured by the screws, the spacers are present, and wiring
is correctly routed.
09/2007
4-56
CAUTION
Phaser 8860/8860MFP Service Manual
Initial Issue