REP 5.0.8 RAM
Parts List on
PL 5.0
Removal
RAM is vulnerable to ESD. Review ESD procedures presented in Section 1.
1.
Loosen the thumbscrews on the back cover of the Electronics Module.
NOTE: Observe the orientation of the RAM device before removing it from the board.
2.
Disconnect the RAM module from the Electronics Module.
Figure 1 Removing RAM
3.
Insert the replacement RAM and close the Back Cover.
Initial Issue
Phaser 8860/8860MFP Service Manual
CAUTION
REP 5.0.9 NVRAM
Parts List on
PL
5.0,
PL 5.1
Removal
NVRAM is vulnerable to ESD. Review ESD procedures presented in Section 1.
1.
Loosen the thumbscrews on the back cover of the Electronics Module.
NOTE: Observe the orientation of the NVRAM devices before removing it from the board.
2.
Exchange the NVRAM devices.
Figure 1 Removing NVRAM
09/2007
4-67
CAUTION
Repairs and Adjustments
REP 5.0.8, REP 5.0.9