Iq28 Incomplete Image Transfer - Xerox Phaser 8860 Service Manual

Table 1 IQ27 Oil Streaks on Print
Step Questions and Actions
5 Check that the Drum Maintenance Cam
Roller and Pivot Plate are functioning cor-
rectly.
Run the Service Diagnostics Drum Mainte-
nance tests.
Does the problem persist?
Initial Issue
Phaser 8860/8860MFP Service Manual
Yes No
Replace any Complete.
defective parts
found.
09/2007

IQ28 Incomplete Image Transfer

This RAP addresses image quality problems associated with the Print Engine. Incomplete
image transfer typically results from coarse, underweight, or watermarked media. Incomplete
image transfer limited to one side of the page may be the result of improper Drum oiling.
Incomplete image transfer can appear as follows:
Figure 1 Example of Incomplete Image Transfer on Output
Initial Actions
1. Check that supported media is being used.
2. Check the Drum Maintenance Kit.
3. Run the Remove Print Smears routine.
Procedure
Table 1 IQ28 Incomplete Image Transfer
Step Questions and Actions
1 Tray using a higher quality print mode.
Does the problem persist?
2 Check that the Drum maintenance Cam
Roller and Pivot Plate are functioning cor-
rectly.
Run the Service Diagnostics Drum Mainte-
nance tests.
Does the problem persist?
3 Clean the Stripper Blade and Exit Guides.
Does the problem persist?
4 Test the Drum temperature regulation.
Run the Service Diagnostics Drum tempera-
ture tests.
Check the Drum Temperature Sensor.
Does the problem persist?
3-21
Yes No
Go to Step 2. Complete.
Replace any Complete.
defective parts
found. If the prob-
lem persists, go to
Step 3.
Go to Step 4. Complete.
Replace the Drum Complete.
Temperature Sen-
sor (REP 6.0.4). If
the problem per-
sists, go to Step 3.
Image Quality
IQ27, IQ28