Xerox Phaser 8860 Service Manual page 154

Figure 4 X-Axis Bias Spring Hook
11. Disconnect the Air Hose from the Purge Pump.
12. Remove 1 (plastic, T-20) screw that secures each Printhead Restraint, and then shift the
restraint inwards toward the Printhead while lifting toward the rear of the printer.
Repairs and Adjustments
REP 2.0.8
Figure 5 Removing the Printhead Restraint Screws
NOTE: Use a flat-bladed screwdriver to rotate the X-Axis Motor to adjust the Printhead
position as needed to remove the Printhead Restraints.
Figure 6 Removing the Printhead Restraints
09/2007
4-30
Initial Issue
Phaser 8860/8860MFP Service Manual