Xerox Phaser 8860 Service Manual page 147

Figure 2 Disconnecting the Drum
16. Disconnect the Drum Encoder harness
the cable from the restraint.
17. Remove 3 (metal, 5.5 mm hex-head) screws, 2 washers, and the Ground Plate from the
right side of the Drum Assembly as shown in
screws as indicated on the label attached to the Drum.
Initial Issue
Phaser 8860/8860MFP Service Manual
P/J120 from the Right Side Harness and release
Figure 3. These are reverse-threaded
Figure 3 Removing the Drum Assembly
18. Remove 3 (metal, T-20) screws and 3 washers from the left side of the Drum Assembly.
NOTE: Do not rest the Drum Assembly on the pulley. Allow the pulley to overhang the sur-
face and rest the assembly on its feet.
19. Lift the Drum Assembly straight out of the chassis using the metal grips provided.
Replacement
The Drum Temperature Sensor harness is routed through the Exit Module. Use care when
reinstalling to avoid damaging the sensor.
NOTE: To help seat the Drum properly, steps 2-6 provide an explicit order of placement for
installing the screws to secure the Drum Assembly to the chassis.
1. Seat the Drum Assembly into the chassis.
2. Align the screw holes in the left and right sides of the Drum Assembly to the holes in the
chassis sides.
3. Install 1 (metal, T-20) screw and washer at the rear position on the left side to hold the
Drum Assembly and torque the screw to 25 in.-lbs.
4. Install the remaining (metal, T-20) screws and washers into the left side of the Drum
Assembly and torque to 25 in.-lbs.
09/2007
4-23
CAUTION
Repairs and Adjustments
REP 2.0.3