Figure 3 Releasing the Printhead Tilt Spring.
10. Pull the X-Axis Bias Spring and Hook out slightly, and then rotate downward to allow it to
rest in detents provided on the frame. See
Repairs and Adjustments
REP 2.0.2
Figure
4.
Figure 4 X-Axis Bias Spring Hook
11. Disconnect the Air Hose from the Purge Pump.
12. Remove the left and right Printhead Restraints. To remove the restraints, remove 1 (plas-
tic, T-20) screw that secures each restraint, and then shift the restraint inwards toward the
Printhead while lifting toward the rear of the printer.
09/2007
4-18
Initial Issue
Phaser 8860/8860MFP Service Manual