Xerox Phaser 8860 Service Manual page 144

Figure 8 Printhead Electrical Connections
15. Remove the 2 (metal, T-20) screws that secure the Ground Strap.
16. Push the Air Hose into the chassis.
17. Lift the Printhead, using the finger recesses as shown in
the shaft in the cradle notches provided near the top of the frame as shown in
Figure 9 Printhead Cradle Notch Location
NOTE: Unlock the connectors before disconnecting the ribbon cables.
Repairs and Adjustments
REP 2.0.2
18. Disconnect the remaining 2 ribbon cables
19. Remove the Printhead as shown in
Figure 11, and place the ends of
Figure 9.
09/2007
4-20
P/J180 and P/J240
Figure 10 Printhead Cable Connections
Figure 11, using the Finger recesses provided.
Phaser 8860/8860MFP Service Manual
from the Printhead.
Initial Issue