Selecting A Stitch Pattern; Saving Stitch Settings; Using The Mirror Image Key - Brother computerized sewing and embroidery machine Operation Manual

Selecting a Stitch Pattern

a
Turn on the machine, and then lightly press
the display.
→ Depending on the setting, either "1-01 Straight stitch
(Left)" or "1-03 Straight stitch (Middle)" is
automatically selected.
b
Press
of the stitches in the selected category, and
then select a stitch pattern.
LSN
* If a different screen is displayed, press
→ An image of the selected stitch pattern is displayed
below the symbol of the appropriate presser foot.
Memo
For details on the stitch patterns, refer to the "STITCH
SETTING CHART" at the end of this manual.

■ Using the Mirror Image Key

Press so that it appears as
image of the selected stitch pattern is created.
Note
If appears as
multi-directional sewing patterns, etc.) is selected, a
mirror image of the selected stitch cannot be created.
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
to display a screen
.
. A mirror
after a stitch (buttonholes,
Tel: 03-91025766/ 5767 Fax: 03-91025768
SELECTING A UTILITY STITCH

Saving Stitch Settings

This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread tension,
automatic thread cutting, automatic reverse/
reinforcement stitching, etc. However, if you wish to
save specific settings for a stitch so that they can be
used later, press after changing the settings to
save the new settings with the selected stitch.
Example: Using a stitch length of 2.0 mm for the
straight stitch
a
Select a straight stitch.
Memo
The default stitch length is 2.5 mm.
b
Set the stitch length to 2.0 mm.
c
Press .
* To reset the selected stitch pattern to its default
settings, press
H/P: 012-6552245
, and then press .
3
49