Upper Threading - Brother computerized sewing and embroidery machine Operation Manual

LOWER/UPPER THREADING
b
Guide the bobbin thread through the groove,
following the arrow in the illustration.
Note
• Do not cut the thread with the cutter.
• Do not attach the bobbin cover.
c
While lightly holding the upper thread, press
the "Needle Position" button twice to lower,
LSN
then raise the needle.
d
Gently pull the upper thread to pull up the
bobbin thread.
→ A loop of the bobbin thread comes out from the hole
in the needle plate.
e
Pull out about 100 mm of the bobbin thread,
and then pass it under the presser foot toward
the rear of the machine, making it even with
the upper thread.
a
Upper thread
b
Bobbin thread
f
Attach the bobbin cover.
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
28
a
b
Tel: 03-91025766/ 5767

Upper Threading

This section describes how to thread the machine and
the needle. The machine is marked with numbers that
indicate the threading order.
• Be sure to thread the machine properly. Improper
threading can cause the thread to tangle and break
the needle, leading to injury.
• When using accessories not included with this
machine, attach the accessory to the machine after
threading the machine.
8
12,13
11
10
9
14,15
a
Turn on the machine.
b
Press the "Presser Foot Lifter" button to raise
the presser foot.
→ The upper thread shutter opens so the machine can
be threaded.
a
a
Upper thread shutter
Memo
This machine is equipped with an upper thread
shutter, allowing you to check that the upper threading
is performed correctly.
Fax: 03-91025768 H/P: 012-6552245
CAUTION
7
4, 5
6
2,16
3
1