Bar Tacks - Brother computerized sewing and embroidery machine Operation Manual

d
Pull down the buttonhole lever.
* The buttonhole lever should be positioned behind
the metal bracket on the buttonhole foot, as shown
in the illustration.
a
a Buttonhole lever
LSN
a Metal bracket

Bar Tacks

Bar tacks are one type of reinforcement stitching used to strengthen points subject to strain, such as ends of pocket
openings and slits.
Stitch Stitch Name
Key
Bar tack
a
Press
b
Set the scale on buttonhole foot "A" to the
desired length of the darning, and then attach
the buttonhole foot.
Memo
The bar tack length can be set between 5 and 28 mm
(approx. 3/16 and 1-1/16 inches). Bar tacks are usually
between 5 and 10 mm (approx. 3/16 and 3/8 inch)
(This differs depending on the application.)
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
a
a
Presser
Foot
Reinforcement at opening of
pocket, etc.
.
Tel: 03-91025766/ 5767
e
Gently hold the end of the upper thread, and
then start sewing.
* Once sewing is completed, the machine
automatically sews reinforcement stitches, then
stops.
* If the automatic thread cutting setting is selected
before sewing, the machine will automatically cut
the thread at the end of stitching.
Note
If the fabric does not feed, for example, because it is
too thick, press
the stitch length.
Applications Stitch Width
[mm (inch)]
Auto
2.0
(1/16)
a Presser foot scale
b Finished measurement
c 5 mm (approx. 3/16 inch)
Fax: 03-91025768 H/P: 012-6552245
SEWING THE STITCHES
in the length display to increase
Stitch Length
[mm (inch)]
Manual Auto Manual
1.0 - 3.0 0.4 0.3 - 1.0
(1/16 - 1/8) (1/64) (1/64 - 1/16)
a
b
c
3
Twin
Needle
NO
79