Alarm - Brother computerized sewing and embroidery machine Operation Manual

LSN
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
This message is displayed when
the motor locks up due to tangled
thread or for other reasons related
to thread delivery.
If data is being written to or deleted
from "Removable Disk" on the
connected computer during
sewing, the machine stops and this
message is displayed.
When the USB transmission is
completed, press the "Start/Stop"
button to continue sewing.
This message is displayed when
the "Reverse/Reinforcement Stitch"
button is pressed while the
embroidery unit is attached.
This message is displayed when
is pressed while an
incompatible embroidery card is
inserted.
This message is displayed when
the machine is set for twin needle
sewing and a pattern that cannot
be sewn with the twin needle is
selected.
Tel: 03-91025766/ 5767 Fax: 03-91025768

■ Alarm

If an incorrect operation is performed, the machine
beeps two or four times.
Memo
To turn the alarm on or off, press
details, see page 21.
H/P: 012-6552245
ERROR MESSAGES
This message is displayed when a
button on the screen is pressed
while the needle is lowered.
This message is displayed when
you try to retrieve a pattern saved
with the number of stitches or the
number of colors exceeding the
specified limits.
This message is displayed when
you try to sew with a stitch other
than a middle needle position stitch
while the single-hole needle plate
is installed.
This message is displayed when
the needle plate is removed with
the machine on or when the
machine is turned on in the
embroidery or embroidery edit
mode.
This message is displayed when
the "Start/Stop" button, "Reverse/
Reinforcement Stitch" button, or
the "Thread Cutter" button is
pressed while the presser foot is
raised.
This message is displayed when
the "Start/Stop" button is pressed
while the sewing speed controller
is set to control the zigzag stitch
width.
. For
8
187