Eyelets; Attaching A 4-Hole Button; Attaching A Button With A Shank - Brother computerized sewing and embroidery machine Operation Manual

SEWING THE STITCHES

■ Attaching a 4-Hole Button

Sew the two holes toward the front. Then, raise the
presser foot, move the fabric so that the needle goes
into the back two holes, and then sew them in the
same way.

■ Attaching a Button with a Shank

a
Pull the shank lever toward you.
LSN
a Shank lever

Eyelets

Eyelets can be used for making belt holes and other similar applications.
Stitch
Stitch Name
Key
Eyelet
a
Press
b
Press
or
the eyelet.
7 mm
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
82
a
Presser
Foot
For making eyelets, holes on
belts, etc.
, and then attach presser foot "N".
or in the width display or
in the length display to set the size of
6 mm 5 mm
Tel: 03-91025766/ 5767
b
When sewing is finished, pull the two ends of
the upper thread between the button and the
fabric, wind them around the shank, and then
tie them together.
c
Tie the ends of the bobbin thread together at
the beginning and end of the stitching on the
wrong side of the fabric
Stitch width
[mm (inch.)]
Applications
Auto.
7.0
(1/4) (1/4 15/64 3/16)
c
Lower the needle into the fabric at the
beginning of the stitching, lower the presser
foot lever, and then start sewing.
* Reinforcement stitches are automatically sewn at the
end of the stitching.
* If the automatic thread cutting setting is selected
before sewing, the machine will automatically cut
the thread at the end of stitching.
a Starting point of stitching
Fax: 03-91025768 H/P: 012-6552245
Stitch length
[mm (inch.)]
Manual Auto. Manual
7.0 6.0 5.0 7.0 7.0 6.0 5.0
(1/4) (1/4 15/64 3/16)
a
Twin
needle
NO