Top Stitching; Smocking - Brother computerized sewing and embroidery machine Operation Manual

b
Leave a seam when sewing the scallop
stitches so that the pattern is not sewn
directly on the edge of the fabric.
Note
Sew test stitches on the fabric before sewing on your
project.
LSN
c
Trim along the seam, making sure not to cut
the stitches.

Top Stitching

For a decorative effect in a crazy quilt, stitches can be
sewn over a pressed seam allowance.
a
Select a straight stitch, and then attach
presser foot "J".
b
Sew together two pieces of fabric with their
surfaces facing each other, and then open the
seam allowances.
a 6.5 mm (1/4inch)
b Wrong side of fabric
c Straight stitch
d Seam allowance
LINGS SERVICE NETWORK (M) SDN BHD, NO 24 Jalan Damai Perdana 1/8C, Bandar Damai Perdana, 56000 Cheras, W.P. Kuala Lumpur
a
d
b
b
c
Tel: 03-91025766/ 5767
c
Turn the fabric over so that the surface faces
up, and then sew over the seam with the
center of the presser foot aligned with the
seam.
* Select one of the following stitch patterns.
a
a Surface of fabric

Smocking

The decorative stitching created by sewing or
embroidering over gathers is called smocking. It is used
to decorate the front of blouses or cuffs.
a
Select a straight stitch, and then attach
presser foot "J".
Note
Make sure that the automatic reverse/reinforcement
stitching and automatic thread cutting settings are not
selected.
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to 2.0
(weaker tension).
c
Pull out 50 mm (approx. 1-15/16 inches) of
both the upper and bobbin threads.
d
Sew stitching 10 mm (approx. 3/8 inch) apart.
a Approximately 10mm (approx. 3/8 inch)
Fax: 03-91025768 H/P: 012-6552245
SEWING THE STITCHES
a
3
69