User Manual of DS-9000/9100/9600 Series DVR
Setting HDD to Read-Only
To set a HDD to read-only:
1.
Navigate to the HDD Management menu by going to Menu > HDD Management. The HDD
Management menu is shown in Figure 8.
Figure 8. HDD Management Menu
2.
Select the General tab.
3.
Select the HDD to set to read-only.
4.
Click the Set button. This will take you to the HDD Settings menu, shown in Figure 9.
Figure 9. HDD Settings Menu
5. Set HDD to Read-Only.
6. Click the OK button. The HDD is now read-only.
Note:
When a HDD is set to read-only, no more recordings can be written to the disk. In order to enable
recordings on that particular disk again, you must set the HDD to R/W (Read/ Write) in the HDD Settings menu.
If multiple HDDs are used, the DVR will automatically record to the next HDD that is not set to read-only.
42