Restoring Default Settings - HIKVISION DS-9000 Series User Manual

User Manual of DS-9000/9100/9600 Series DVR
To update via a FTP server:
1. Configure PC (running FTP server) and DVR to be in the same Local Area Network. Run the
3rd-party TFTP software on the PC and copy the firmware into the root directory of TFTP.
2. Enter the Firmware Update menu by clicking Menu > Maintenance > Upgrade.
3.
Select the FTP tab, shown in Figure 12.
Figure 12. FTP Firmware Update
4. Input the FTP server address.
5. Select Upgrade to begin update process.
6. After the system firmware has been update, reboot the DVR.
Note:
If the DVR fails to update, please contact your system supplier for further assistance.

Restoring Default Settings

To restore default factory settings to your DVR:
1. Enter the Default Settings menu, shown in Figure 13 by clicking Menu > Maintenance >
Default.
Figure 13. Default Settings Menu
Select OK to restore factory defaults.
Note:
Network information such as IP address, subnet mask and gateway will not be restored.
127