Setting Hdd To Read-Only - HIKVISION DS-7200-ST Series User Manual

User Manual of DS-7200-ST Series DVR

Setting HDD to Read-Only

To set a HDD to read-only:
1. Click Menu > HDD to access the HDD Management dialog box, shown in Figure 8.
Figure 8. HDD Management Menu
2. Select the General tab.
3. Select the HDD to set to read-only.
4. Click the Property button to enter the Property Settings dialog box, shown in Figure 9.
alarm shop
Figure 9. HDD Property Settings Menu
5. Set HDD Status to Read-only and then click OK to finish the settings.
Notes:
1. Once set to read-only, the HDD cannot be written to until it is set back to read/write (R/W).
2. DS-7204HVI-ST, DS-7204HVI-ST/SE, DS-7208HVI-ST/SE, DS-7204HFI-ST, DS-7204HFI-ST/SE,
DS-7200HVI-ST/SN, DS-7200HFI-ST/SN and DS-7204HVI-ST/L models can be installed with one HDD
only, therefore, when the property is set to read-only, the recording of the device will be stopped.
52