Names And Functions Of Objects On The Lcd Display - Korg Oasys Operation Manual

Names and functions of objects on the LCD display

a: Current page
e: (Category) popup button
d: Popup button (2)
b: Edit cell
c: Popup button (1)
h: Page tab
g: Page group Tab
The OASYS uses Korg's TouchView graphical user
interface.
By touching on objects displayed in the LCD screen,
you can select pages, set parameter values, rename
programs and combinations, write data, and perform
many other operations.
a: Current page
This indicates the selected page within the current
mode.
From the left, this shows the current mode, the number
and name of the page group, and finally the name of
the individual page.
b: Edit cell
When you touch a parameter in the LCD screen, the
parameter or parameter value will usually be
highlighted (displayed in inverse video). This is called
the edit cell, and the highlighted item will be subject to
editing.
The parameter value of the edit cell can be modified
using the VALUE controllers (+p.39) or by using a
popup button in the LCD screen. For parameters that
accept a note number or a velocity value, you can also
hold down the ENTER switch and play a note on the
keyboard to enter the note number or velocity value.
c: Popup button
When this button is pressed, a popup menu will
appear, showing the parameter values that are
available for selection.
Front and rear panels
Mode name Page number
Names and functions of objects on the LCD display
f: Check box
To enter the parameter value, press the desired value in
the popup menu.
When a popup menu is displayed, using a VALUE
controller (+p.39) will close the popup menu. If the
popup menu is unlocked (+"Pin"), it will close if you
touch a location outside the popup menu.
* Popup menu
Pin
This switches the popup menu display
between locked and unlocked.
When locked, the pin will be shown closed, and the
popup menu will remain displayed even after you
press a parameter value. When unlocked, the pin will
be shown opened, and the popup menu will close
immediately when you press a parameter value.
d: Select button
When you press this button, a tabbed popup menu
will appear, allowing you to perform the following
selections.
• "Bank/Program Select," "Bank/Combination
Select": Select programs or combinations by bank
• "Multisample Select": Select a multisample for a
program oscillator by category
• "Wave Sequence Select": Wave sequences for
program oscillators can be chosen by category
• "Effect Select": Select an effect by category
• Select a sample
• Select a KARMA GE
To close a tabbed popup menu, press the OK button or
Cancel button.
Page name i: Page menu button
Pin
31