Korg Oasys Operation Manual page 59

An example of settings in a Program
When using SW1/2 for AMS or Dmod, the default
settings are SW1 Mod.:CC#80 and SW2 Mod.:CC#81.
For an example, see "Using Dmod to change the
feedback level via SW1" on page 195. For a complete
list of the possible assignments, see "SW1/2
Assignments" on page 1033 of the Parameter Guide.
Note: If you wish to keep these settings after the power
is turned off, you must save the Program,
Combination, or Song. Settings for Sampling mode
cannot be saved.
Using the Lock function
Locking the Joystick
1. Using the standard factory sounds, select Program
INT‐A016: Real Suit E.Piano, and play the
keyboard.
To select a program, make sure that you are in
Program mode, and press the BANK INT A button,
numeric key 1, 6, and then the ENTER key.
2. Move the joystick away from yourself (the +Y
direction).
The vibrato effect will deepen.
3. While holding the joystick away from yourself,
press the SW2 switch.
When you press the switch, its LED will light up,
and the modulation effect at this point will be
maintained.
4. Release the joystick, and play the keyboard.
The modulation will stay the same as it was when
SW2 was pressed. Moving the joystick away from
yourself will not affect the sound.
SW 1 SW 1 SW 2 SW 2
5. Press the SW2 key once again to release the Lock
function.
Locking the Ribbon Controller
Make sure that the INT‐A016: Real Suit E.Piano
program is selected.
1. Press the SW2 key.
The LED on SW2 will light up.
2. Touch the ribbon controller, and move your finger
left and right.
Movement in the +X direction will brighten the tone,
and movement in the –X direction will darken the
tone.
3. Lift your finger up from the ribbon controller.
The sound will remain as it was when you last
touched the ribbon.
4. Press the SW2 key once again to release the Lock
function.
5. Press the tab labeled Cntrl/View Effect, to go to the
Controller/View Effect page.
In the upper right‐hand portion of the screen, notice
that SW2 is assigned to JS Y & Ribbon Lock, and is set
to Toggle. This means that SW2 is assigned to control
the Lock function for both the joystick's Y axis and the
ribbon controller. Many Programs and Combinations
use this assignment.
You can also lock both the ribbon and the joystick at
the same time:
1. Move the joystick in the +Y direction
2. Press the SW2 key to turn on the Lock function.
3. Move your finger on the ribbon controller.
4. Release the joystick, and lift your finger up from
the ribbon.
The effects of both the ribbon and the joystick will be
maintained until you press SW2 again to release the
lock.
Lock can also be applied to aftertouch, by assigning
SW1 or SW2 to After Touch Lock.
For details on the functions that you can assign to SW1
and SW2, please see the "SW1/2 Assignments," on
page 1033 of the Parameter Guide.
Control Surface knobs, sliders, & switches
The Control Surface has 8 knobs, 8 sliders plus a
master slider, and 16 switches. You can use these for
many different tasks:
• Controlling mixer features, including volume, pan,
EQ, FX sends, mute, and solo
• Modulating and editing sounds
• Controlling KARMA
• Controlling external MIDI devices
You can switch the Control Surface between its
different functions using either the on‐screen tabs on
the Control Surface page, or the front‐panel Control
Assign switches. The tabs and the front‐panel switches
mirror one another; when you change one of them, the
other changes as well.
Using Controllers
51