Korg Oasys Operation Manual page 181

Open architecture synthesis studio
Hide thumbs Also See for Oasys:
Table of Contents

Advertisement

Press the Shift button once again to switch to lowercase 
characters, and press the characters r, o, g, r, a, m, 0, 1.
3. Press the OK button to close the dialog box.
If you don't need to make any corrections, press the 
OK button to close Write Program.
Memory protect
To prevent programs, combinations, songs, drum kits, 
wave sequences, and KARMA GE from being 
overwritten accidentally, the OASYS provides a 
Memory Protect setting that prohibits writing to 
memory.
Before you save edited data or load data from media, 
use the following procedure to turn the memory 
protect off (uncheck the appropriate check box).
You must also turn memory protect off before loading 
the above data from media or via a MIDI data dump, 
or before recording in Sequencer mode.
1. Press the GLOBAL switch to enter Global mode.
2. Access the Global P0: Basic Setup– Basic page, and 
select the Basic page.
Press the Basic tab at the bottom, and then press the 
Basic tab above it.
3. Press the "Memory Protect" check box for the type 
of data you wish to write to internal memory, so 
that the box is unchecked.
Writing global settings
The settings you edit in Global mode P0–P3 can be 
written into internal memory as Global settings. If you 
wish to use these edited settings after you turn the 
power off, be sure to write the data first.
The wave sequences and drum kits you edit in Global 
mode P4 and P5 must be written as individual wave 
sequences and drum kits.
There are two ways to write global settings.
Using a page menu command to write
1. To write global settings (the various settings in 
Global P0–P3), press the page menu command 
Write Global Setting in Global P0–P3.
The Write Global Setting dialog box will appear.
Saving data
Writing to internal memory
Note: The same dialog box will also appear if, in each of 
the above pages, you hold down the ENTER switch 
and press the 0 switch. (See "Shortcuts" on page 27)
2. To execute the Write operation, press the OK 
button. To cancel, press the Cancel button.
When you press the OK button, the display will ask 
"Are you sure?" Press the OK button once again to 
write the data.
Using the (SEQUENCER) REC/WRITE
switch to write
1. In the Global P0–P3 pages, press the SEQUENCER 
REC/WRITE switch.
A dialog box will appear.
2. To execute the Write operation, press the OK 
button. To cancel, press the Cancel button.
l Memory in Global mode P0–P3
When the power is turned on, the Global mode P0–P3 
data is called from internal memory into the Global 
mode memory area. Then when you modify the 
parameters in Global mode, the data in the memory 
area will be modified. If you wish to save this modified 
data in internal memory, you must Write it.
When you write this data, the data in the memory area 
is written into the global settings.
If you turn off the power without writing, the modified 
data in the memory area will be lost.
Memory Area
When you Write, the
various Global mode
P0–P3 settings will be
Write
saved in internal memory.
Internal Memory
Global Setting
P0...P3
Editing will affect the data that has
been called into the memory area.
Edit
When the power is
turned on, the settings
are called into the
Power On
memory area.
173

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents