Aborting Cloud Deployment Process By User; Re-Trigger Cloud Deployment; Deployment Errors - Siemens A31003-D3000-M100-01-76A9 Administrator User Manual

Startup
Cloud Deployment (V3 R1)

2.5.2 Aborting Cloud Deployment Process by User

2.5.3 Re-trigger Cloud Deployment

2.5.4 Deployment errors

38
The phone exits the cloud
deployment process and enables
the mode keys & FPKs etc. to act
as normal
Phone removes the Progress
prompt and displays a timed
success pop-up, indicating that the
cloud deployment is done
The phone verifies that it now has
an E.164 address
Registered
Related Topics
The phone detects that a cloud deployment is required and starts the cloud
deployment process. The phone expects the input of the PIN by the user. At this
point the user has the option to cancel the process with Cancel. If the user
confirms his decision, the deployment process is aborted.
Related Topics
Cloud deployment may be restarted by triggering a Factory reset:
The DLS-WPI requests a restart to factory defaults of the phone. The phone
restart should then trigger the cloud deployment process if the conditions in Cloud
Deployment are still met.
Related Topics
During deployment the display will always show deployment specific information.
A persistent warning popup displays the information that will be shown in an idle
screen error after deployment failed.
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
A31003-D3000-M100-01-76A9, 02-2013