Group Pickup; Addressing - Via Group Pickup Uri Feature Code; Pickup Alert - Siemens A31003-D3000-M100-01-76A9 Administrator User Manual

Administration
Feature Configuration

3.7.4 Group Pickup

3.7.4.1 Addressing - via Group Pickup URI Feature Code

3.7.4.2 Pickup Alert

108
This feature is only available when enabled under System > Features > Feature
access (see Feature Access).
Related Topics
This feature allows a user to collect a call from any ringing phone that is in the
same pickup group. To be a member of a Call Pickup group, the phone must be
configured with the corresponding URI of the Call Pickup Group service provided
by the server. An example pickup URI is "**3".
Administration via WBM
INFO: The BLF pickup code parameter is only relevant when the
phone is connected to an Asterisk server.
System > Features > Addressing
Related Topics
If desired, an incoming call for the pickup group can be indicated acoustically and
visually if Group pickup visual alert is configured.
The Group pickup tone allowed parameter activates or deactivates the gener-
ation of an acoustic signal for incoming pickup group calls. The default is "Yes". If
this is activated, Group pickup as ringer determines whether the current ring
tone or an alert beep is used. If set to "Yes", a pickup group call will be signaled
by a short ring tone; the currently selected ringtone is used. If set to "No", a pickup
group call will be signaled by an alert tone. The default is "Yes".
Depending on the phone state and the setting for Group pickup as ringer, the
group pickup tone comes from the loudspeaker, the handset, or the headset. The
volumes can be set in the local User menu, under Audio > Volumes.
The following table shows the group pickup alert behavior for each possible
scenario:
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
A31003-D3000-M100-01-76A9, 02-2013