View Report - Siemens A31003-D3000-M100-01-76A9 Administrator User Manual

Administration
Diagnostics

3.23.11.2 View Report

218
| |--- Minimum session length
|--- Send now
|--- Thresholds
|--- Maximum jitter
|--- Round-trip delay
|--- Non-compressing:
|--- ...Lost packets (K)
|--- ...Lost consecutive
|--- ...Good consecutive
|--- Compressing:
|--- ...Lost packets (K)
|--- ...Lost consecutive
|--- ...Good consecutive
Related Topics
OpenScape Desk Phones generate QoS reports using a HiPath specific format,
QDC (QoS Data Collection). The reports created for the last 6 sessions, i. e.
conversations, can be viewed on the WBM.
To enable the generation of reports, please ensure that:
• the switch QoS traps to QCU (System > SNMP) is activated (see SNMP);
• the conditions for the generation of reports are set adequately (seeConditions
and Thresholds for Report Generation).
For details about QoS reports on HiPath devices, see the HiPath QoS Data
Collection V 1.0 Service Manual.
A QoS report contains the following data:
• Start of report period - seconds: NTP time in seconds for the start of the
report period.
• Start of report period - fraction of seconds: Additional split seconds to be
added to the seconds for an exact start time.
• End of report period - seconds: NTP time in seconds for the end of the
report period.
• End of report period - fraction of seconds: Additional split seconds to be
added to the seconds for an exact end time.
• SNMP specific trap type: The trap type is a 5 bit value calculated from a list
of threshold-exceeding bits. Every time a threshold is exceeded, the
associated bit is set, otherwise it is cleared.
The trace type bits are defined as follows:
– Bit 0: Jitter threshold was exceeded.
– Bit 1: Delay threshold was exceeded.
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
A31003-D3000-M100-01-76A9, 02-2013