Siemens A31003-D3000-M100-01-76A9 Administrator User Manual page 152

Administration
Multiline Appearance/Keyset
152
LED on registration determines whether the line LEDs will be lit for a few
seconds if they have been registered successfully with the SIP server on phone
startup.
The Originating line preference parameter determines which line will be used
when the user goes off-hook or starts on-hook dialing.
INFO: When a terminating call exists, the terminating line
preference takes priority over originating line preference.
The following preferences can be configured:
• "idle line": An idle line is selected. The selection is based on the Selection
order parameter assigned to each line (see Line Key Configuration).
• "primary": The designated Primary Line/Main DN is always selected for origi-
nating calls.
• "last": The line selected for originating calls is the line that has been used for
the last call (originating or terminating).
• "none": The user manually selects a line by pressing its line key before going
off-hook or by pressing the speaker key, to originate a call.
Manual line selection overrides automatic line preferences.
The Terminating line preference parameter decides which terminating line, i. e.
line with an incoming call, is selected when the user goes off-hook.
The following preferences can be configured:
• "ringing line": The line in the alerting or audible ringing state is automatically
selected when the user goes off-hook. In the case of multiple lines alerting or
ringing, the lines are selected on the one that has been alerting the longest.
• "ringing PLP": The line in the alerting or audible ringing state is automatically
selected when the user goes off-hook. However, if the prime line is alerting, it
is given priority.
• "incoming": The earliest line to start audible ringing is selected, or else the
earliest alerting (ringing suppression ignored) line is selected.
• "incoming PLP": The earliest line to start audible ringing is selected, or else
the earliest alerting (ringing suppression ignored) line is selected. However, if
the prime line is alerting, it is given priority.
• "none": To answer a call, the user manually selects a line by pressing its line
key be-fore going off-hook, or by pressing the speaker key.
Manual line selection overrides automatic line preferences.
Line action mode determines the consequence for an established connection
when the line key is pressed. If "hold" is selected, the call currently active is set to
hold as soon as the line key is activated. The user has two options: 1) to
reconnect to the remote phone by pressing the line key that corresponds to that
call, or 2) to initiate another call from the newly selected line. If "release" is
selected, the previously established call is ended.
If Show Focus is checked, the LED of a line key flutters when the line is in use.
If it is not checked, the line key is lit steady when it is in use.
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
A31003-D3000-M100-01-76A9, 02-2013