How To Set Up And Deploy A Dial Plan - Siemens A31003-D3000-M100-01-76A9 Administrator User Manual

Examples and HowTos
Example Dial Plan

5.3.3 How To Set Up And Deploy A Dial Plan

Prerequisites
Step by Step
236
• Minimum length: The dial plan rule will not initiate the sending of digits until
at least this number of digits have been entered. However, the digits will be
sent after the delay configured in User menu > Configuration > Outgoing
calls > Autodial delay (seconds).
• Maximum length: Automatic sending will occur when this number of digits
have been dialed. If not specified, then the digits will be sent when the timer
expires, or a terminating character is entered.
• Timer: This indicates the timeout to be used for subsequent digit handling. If
not specified, the default timer value is used (User menu > Configuration >
Outgoing calls > Autodial delay (seconds)).
• Terminating character: A "*" or "#" character which indicates that the
preceding digits should be considered complete, even though the maximum
length may not be reached. However, the reach the minimum length must be
reached by the string built from the digits entered and the terminating
characters.
• Special indication:
– "E" (Emergency): If this character is entered here, the digits matching this
rule will be sent even if the phone is locked. The number will be dialed
immediately even when immediate dialing is disabled, and the phone is
on-hook.
– "b" (bypass): The phone lock is bypassed. The number will be dialed
immediately even when immediate dialing is disabled, if the phone is off-
hook.
• Comment: A remark on this dial plan entry.
• Terminator sent: If set to true, the terminating character is sent to the server
along with the dial string proper. If set to false, the dial string is sent without
the terminating character.
Related Topics
• For creating and deploying a dial plan to an OpenScape Desk Phone, a
working installation of the DLS (version V2R4 onwards) is required. This
HowTo describes the creation of a simple dial plan for OpenScape Desk
Phones by example. Unless otherwise stated, the actions described under-
neath are performed in the DLS.
1) Log on to the DLS with an account that has suitable rights for deploying a dial
plan. For details, please refer to the Deployment Service Administration
Manual.
2) Navigate to IP Devices > IP Phone Configuration > Features > "Dialplan" tab.
3) Check dial plan, if not checked already.
4) Enter a suitable dial plan ID.
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
A31003-D3000-M100-01-76A9, 02-2013