Example Dial Plan; Introduction; Dial Plan Syntax - Siemens A31003-D3000-M100-01-76A9 Administrator User Manual

5.3 Example Dial Plan

5.3.1 Introduction

5.3.2 Dial Plan Syntax

A31003-D3000-M100-01-76A9, 02-2013
OpenScape Desk Phone IP, Phone Administration, Administrator Documentation
The following status is displayed for the MAC_Phy config parameters:
AutoSet enabled = Incompatible
MAU = Incompatible
Related Topics
Related Topics
A dial plan is a set of rules that determine the phone's behavior on digit entry by
the user. Up to 48 rules are possible. With OpenScape Desk Phones, a dial plan
rule is constructed from 9 parameters. In the following, the setup of a dial plan is
explained.
The dial plan entries are preceded by a title line. This is a free format string, e. g.
a descriptive name or version number, which can be used by the administrator for
version control purposes.
Related Topics
INFO: The phone will not perform any checking on the title;
ensuring that different dial plans are given different titles is part of
the administration process.
A dial plan rule is built from the parameters described underneath.
• Digit string: A pattern of digits or "*", "#", or "x" characters that is to be
matched for starting an action. The maximum length is 24 characters. The "x"
character is a wildcard character that represents any of the other digits (it may
be upper or lower case).
• Action: The action to be taken when the criteria are met. The following
options are available:
– "S" (Send digits): The digits entered are sent to the server when one of
the following three conditions is satisfied:
a) the maximum digits have been received, or
b) the timer expires after the minimum digits have been received, or
c) on receipt of the terminator after the minimum digits.
– "C" (Check for other actions): If the digit sequence entered by the user
matches Digit string, Maximum length, and Minimum length, the timer
starts. On timer expiry, the digit string will be sent to the server. If further
digits are received before timer expiry, further entries will be checked. If
the timer is set to 0, the dial string will be sent immediately. This option is
used when there are more than one rules which start with the same digits.
Examples and HowTos
Example Dial Plan
235