Assembling The Power Trim And Tilt Unit - Yamaha 200A Service Manual

10. Install the tilt cylinder end cap 4 on the tilt
rod 5.
11. Install a new O-ring 67 on the tilt piston
8. Also install the ball 9, absorber pin 0,
and spring A in this order.
12. Install the tilt piston sub-assembly and
washer B on the tilt rod 5, and tighten the
nuts C.
Tilt piston nut:
96 N • m (9.6 kgf • m, 71 ft • lb)
13. Install new backup ring E and the O-ring
F on the free piston D.
15
16
14. Install new oil seal G, dust seal H, backup
ring I, and O-ring J, K on the trim cylin-
der end cap and the trim piston.
60H5E11
60h70870

Assembling the power trim and tilt unit

1. Fill the tilt cylinders with the fluid.
NOTE:
60H70880
Fill the tilt cylinders with the specified quantity
60h70880
of recommended fluid through the hole A.
14
2. Push-in the free piston 1 to the bottom of
tilt cylinder.
60H70890
60h70890
Tilt cylinder and trim cylinder
A
Recommended power trim and tilt
fluid:
ATF Dexron II
Specified quantity:
3
30 cm (1.1 Imp oz)
60h70900
60h70920
7
1
60H70930
60h70930
7-36