Assembling The Trim Cylinder - Yamaha FT50C Service Manual

9. Install the relief valve bracket H by
installing the bolts I, then tightening
them to the specified torque.
Relief valve bracket bolt I:
5.3 N·m (0.53 kgf·m, 3.8 ft·lb)
10. Install the filters J and gear pump K by
installing the bolts L, then tightening
them to the specified torque.
11. Install the manual valve M and reservoir
cap N.
62Y5A11
Gear pump bolt L:
6.5 N·m (0.65 kgf·m, 4.7 ft·lb)
12. Fill the reservoir with the recommended
fluid to the correct level as shown.
Recommended power trim and tilt
fluid:
ATF Dexron II
13. Install the joint O and power trim and tilt
motor P by installing the bolts Q, then
tightening them to the specified torque.
PTT motor bolt Q:
4 N·m (0.4 kgf·m, 2.9 ft·lb)

Assembling the trim cylinder

1. Install the dust seal 1 into the tilt cylinder
end screw 2.
Gear pump
1
2
3
4
5
6
7
8
9
7-38