Checking The Hydraulic Pressure - Yamaha F150A Service Manual

NOTE:
Hold the power trim and tilt unit with one
hand, and pull the upper mount shaft out at a
downward angle with the other.
6. Remove the collars.

Checking the hydraulic pressure

1. Remove the reservoir cap, and then
check the fluid level in the reservoir.
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
reservoir cap is removed.
2. If necessary, add sufficient fluid of the
recommended type until it overflows out
of the filler hole.
63P3F11
3. Install the reservoir cap, and then tighten
it to the specified torque.
4. Fully extend the trim and tilt rams.
5. Remove the circlip 1, then the manual
valve 2.
6. Install the up relief fitting 3 and hydraulic
pressure gauge 4.
S60X7120
NOTE:
Quickly install the special service tools before
S60X7340
any fluid flows out of the hole.
Power trim and tilt unit
Recommended power trim and tilt
fluid:
ATF Dexron II
Reservoir cap:
0.7 N·m (0.07 kgf·m, 0.5 ft·lb)
Up relief fitting 3: 90890-06773
Hydraulic pressure gauge 4:
90890-06776
1
2
3
4
5
6
7
8
9
7-28