Assembling The Power Trim And Tilt Motor; Installing The Power Trim And Tilt - Yamaha FT50C Service Manual

BRKT
7. Check the base for cracks or damage.
Replace if necessary.
8. Check the bushing 1 for damage or
wear. Replace if necessary.
Assembling the power trim and tilt
motor
1. Install the oil seal 1 and the bushing 2
into the motor base 3 as shown.
2. Attach the circuit breaker 4 onto brush 1
5 together with the brush holder 6 and
connect the wire lead 7.
3. Install the springs 8 into the motor base,
then the brush holder into the motor base
together with the brushes and circuit
breaker.
7-45
Bracket unit
4. Install the armature 9, O-ring 0, and
yoke A.

Installing the power trim and tilt

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
NOTE:
After tilting up the outboard motor, be sure to
support it with the tilt stop lever.
62Y5A11