LOWR
2. Install the needle bearing outer case into
the lower case.
É
NOTE:
Apply engine oil to the needle bearing outer
case before installation.
Bearing outer race attachment 3:
90890-06628
Bearing outer race puller 4:
90890-06523
3. Install the needle bearing into the needle
bearing outer case.
NOTE:
Apply engine oil or grease to the needle
bearing, and then install it.
Assembling the forward gear
1. Install the new taper roller bearing into
the forward gear using a press.
É
Bearing inner race attachment 1:
90890-06659
Assembling the drive shaft housing
1. Install the needle bearing into the drive
shaft housing to the specified depth.
6-21
Lower unit
Needle bearing attachment 1:
90890-06610
Driver rod LS 2: 90890-06606
Depth a:
4.25–4.75 mm (0.167–0.187 in)
2. Apply grease to the new oil seals, and
then install them into the drive shaft
housing to the specified depth.
É
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Bearing outer race attachment 3:
90890-06628
Driver rod LS 4: 90890-06606
Depth b:
0.25–0.75 mm (0.01–0.03 in)
Installing the drive shaft
1. Install the forward gear to the lower case.
69J3D11