b. Apply the specified pressure. Check that
the pressure is maintained in the lower unit
for 10 seconds or more.
Do not overpressurize the lower unit. Oth-
erwise, the oil seals could be damaged.
Lower unit
Holding pressure
68.6 kPa (0.69 kgf/cm², 9.9 psi)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Installing the lower unit
• Make sure to disconnect the battery ca-
bles from the battery, and remove the clip
from the engine shut-off switch.
• When installing the lower unit with the
power unit installed, make sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could fall suddenly and
result in severe injuries.
• When loosening or tightening the propel-
ler nut, do not hold the propeller using
your hands.
1. Check that the pin "a" is aligned with the
alignment mark "b" on the shift bracket "1".
a
1
b
2. Set the gear shift to the N position.
R
N
Shift rod socket "1"
90890-06681
Shift rod socket "1"
YB-06681
3. Install:
• Dowel pin "1"
• Speedometer hose "2"
• Hose joint
• Plastic tie
• Lower unit
• Lower case mounting bolt "3"
• Lower case mounting bolt "4"
• Trim tab "5" (original position)
• Anode "6"
2
1
3
Lower case mounting bolt "3" and
"4"
40 N·m (4.0 kgf·m, 30 lb·ft)
8-22
Drive shaft and lower case
1
F
New
1
4
3
3
6
5