7. Install the collar 6, cover 7, clip 8,
drive pawl 9, spring 0, spring q, and
drive plate w.
8
7
w
q
0
8. Turn the sheave drum 6 times in the
direction of the arrow shown, and then
remove the starter rope from the notch
e.
9. Pull the manual starter handle several
times to check that the sheave drum
turns smoothly and to check the starter
rope for slack. Repeat steps 4—8 if nec-
essary.
69D5G11
NOTE:
Align the mark on the stopper with guide, and
then turn the sheave drum.
10. Pull the manual starter handle complete-
6
69D50115
9
69D50120
Removing the power unit
NOTE:
It is recommended to loosen the flywheel
magnet nut before removing the power unit to
improve working efficiency.
1. Remove the carburetor assembly.
2. Remove the start-in-protection cable 1,
e
69D50130
69D50140
ly, then measure the starter rope length.
Adjust if the starter rope length is out of
specification.
Starter rope length f:
1,700–1,900 mm (66.9–74.8 in)
and then remove the manual starter.
1
Power unit
1
2
3
69D50150
4
5
6
7
8
69D50160
9
5-18