MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking gas Bowden cable route
9.43
Checking play in the gas Bowden cable
9.44
Adjusting the gas Bowden cable play
9.45
–
Position the handlebar clamps
Elastomer kit green - soft quality (SXS05125203)
Elastomer kit yellow - medium quality (standard) (SXS05125204)
Elastomer kit red - hard quality (SXS05125205)
Info
The elastomers are available in different versions.
–
Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
–
The two gas Bowden cables must run parallel behind the handlebar down to the
frame. They must be routed directly on the frame above the tank bearing to the car-
buretor.
500152-10
–
Move the handlebar to the straight-ahead position. Move the throttle grip back and
forth slightly to ascertain the play in the gas Bowden cable.
Play in gas Bowden cable
»
If the gas Bowden cable play does not meet specifications:
–
Adjust the gas Bowden cable play.
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
400192-10
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the gas Bowden cable play.
x
–
Dismount the fuel tank.
–
Check gas Bowden cable route. (
with rubber washers
.
M8
3... 5 mm (0.12... 0.2 in)
(
p. 50)
x
(
p. 50)
x
x
(
p. 70)
p. 50)
50
and elastomers
.
16 Nm
(11.8 lbf ft)