MAINTENANCE WORK ON CHASSIS AND ENGINE
Measuring rear wheel sag unloaded
9.8
Checking static sag of the shock absorber
9.9
–
Turn the adjusting screw
Info
Do not loosen nut
–
Turn back counterclockwise the number of clicks corresponding to the shock
absorber type.
Guideline
Rebound damping
400210-10
Comfort
Standard
Sport
Info
Turn clockwise to increase damping, turn counterclockwise to reduce sus-
pension damping.
–
Jack up the motorcycle. (
–
Measure the distance – as vertical as possible – between the rear axle and a fixed
point, for example, a mark on the side cover.
–
Make a note of the value as measurement
0 0 A
A
–
Remove the motorcycle from the work stand. (
400220-10
–
Measure distance
–
Ask someone to help you by holding the motorcycle upright.
–
Measure the distance between the rear axle and the fixed point again.
A
0 0 A
–
Make a note of the value as measurement
Info
The static sag is the difference between measurements
–
Check the static sag.
Static sag
»
If the static sag is less or more than the specified value:
–
Adjust the spring preload of the shock absorber.
B
0 0 0 B
400221-10
clockwise until it stops.
!
26 clicks
24 clicks
22 clicks
p. 33)
.
of rear wheel unloaded. (
.
35 mm (1.38 in)
p. 33)
p. 35)
and
.
x
(
p. 36)
35