MAINTENANCE WORK ON CHASSIS AND ENGINE
Mounting oil filter
x
9.113
Filling up with engine oil
9.114
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Remove screws
200113-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing area.
200114-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter
–
Lubricate the O-ring
200114-11
–
Refit the oil filter cover
–
Mount and tighten screws
Guideline
Screw, oil filter cover
–
Stand the motorcycle up.
200113-11
x
–
Remove the screw cap
Engine oil
–
Mount and tighten screw cap
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
–
200115-10
–
Start the engine and check that it is oil-tight.
–
Check the engine oil level. (
. Remove oil filter cover
out of the oil filter casing.
with engine oil and place it in the oil filter container.
of the oil filter cover.
.
.
on the generator cover and fill up with engine oil.
0.60 l (0.63 qt.)
.
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
p. 79)
with O-ring.
M6
10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
81
p. 106)