Removing Rear Wheel; Installing The Rear Wheel - KTM 400 EXC EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing rear wheel

x
9.76

Installing the rear wheel

9.77
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake pads are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand. (
500084-11
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Fully tighten screw
Guideline
Screw, fork stub
–
Jack up the motorcycle. (
–
Press the brake caliper by hand on to the brake disc in order to press back the
brake piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
rear wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
400258-10
–
Remove the spacing sleeves
400260-11
x
.

.

p. 33)
.

. Withdraw the wheel spindle

.

M24x1.5 45 Nm
(33.2 lbf ft)
p. 33)
M8 15 Nm
(11.1 lbf ft)
only enough to allow the

65