Riding Instructions; Checks Before Putting Into Operation; Starting - KTM 400 EXC EU Owner's Manual

RIDING INSTRUCTIONS

7 R IDING INSTRUCTIONS

Checks before putting into operation

7.1
Info
Make sure that the motorcycle is in a perfect technical condition before use.
Info
In the interests of riding safety, make a habit of making a general check before you ride.
–
Check the engine oil level. (
–
Check the chain tension. (
–
Check for chain dirt accumulation. (
–
Check the tire condition. (
–
Check the tire air pressure. (
–
Check the front brake fluid level. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check brake system function.
–
Check the coolant level. (
–
Check that all operating elements are correctly adjusted and free to move.
–
Check the functioning of the electrical equipment.

Starting

7.2
Danger
Danger of poisoning Exhaust gases are poisonous and can result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in a closed
space.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the fuel
evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds until trying again.
Motorcycle has been out of use for more than 1 week
–
Empty the carburetor float chamber.
–
Turn handle of the fuel tap to the ON position. (Figure 500137-10

Fuel can flow from the fuel tank to the carburetor.
–
Remove the motorcycle from the stand.
–
Shift gear to neutral.
(EXC AUS)
–
Turn the emergency OFF switch to the position
Engine cold
(EXC AUS, XC‑W)
–
Pull the choke lever out as far as possible.
(EXC EU, EXC SIX DAYS)
–
Pull the choke lever to the stop.
–
Press the electric starter button or press the kickstarter robustly through its full range.
Info
Don't open the throttle.
p. 79)
p. 52)
p. 51)
p. 66)
p. 67)
p. 57)
p. 61)
p. 58)
p. 62)
p. 72)
( p. 79)
x
.
p. 20)
26