Fitting The Start Number Plate; Handlebar Position; Adjusting Handlebar Position; Checking Gas Bowden Cable Route - KTM 450 SX-F Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Fitting the start number plate

8.36

Handlebar position

8.37
A 0 0 A
B 0 0 B

Adjusting handlebar position

8.38
1 0 0 1
2 0 0 2

Checking gas Bowden cable route

8.39
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Position the start number plate. Mount and tighten screw
Rules
Remaining screws, chas-
sis
Info
Take care with the contact of the holding lug at the fender.
500123-11
–
Position brake line. Put the clamp on, mount and tighten screw
On the upper triple clamp, there are 2 holes at a distance of
Drilling distance A:
The holes on the handlebar support are placed at a distance of
Drilling distance B:
The handlebar can be mounted in 4 different positions. This enables you to mount the
handlebar in the position most suitable for the rider.
400271-11
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two screws
.
2
400271-10
Rules
Screw, handlebar
support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
Rules
Screw, handlebar clamp
–
The two gas Bowden cables must run parallel behind the handlebar down to the
frame. They must be routed directly on the frame above the tank bearing to the
carburetor.
400268-10
M6
15 mm (0.59 in)
3.5 mm (0.14 in)
. Remove the handlebar clamp. Remove the handlebar
1
. Remove the handlebar support.
2
M10 40 Nm
(29.5 lbf ft)
M8
32
.
1
10 Nm (7.38 lbf ft)
.
2
to each other.
A
from the center.
B
Loctite ® 243™ ( 84)
.
1
20 Nm (14.75 lbf ft)