MAINTENANCE WORK ON CHASSIS AND ENGINE
Dismount the start number plate (XC‑W USA)
9.39
Installing the start number plate (XC‑W USA)
9.40
Handlebar position
9.41
0 0 A
A
A
0 0 A
B
0 0 B
Adjusting handlebar position
9.42
1
0 0 1
2
0 0 2
–
Position the headlight mask and fix it with the rubber band
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw
.
–
Check the headlamp setting.
800018-11
–
Remove screw
–
Remove screw
500101-10
–
Position the start number plate. Mount and tighten screw
bushing.
Guideline
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
500101-11
screw
.
On the upper triple clamp, there are 2 holes at a distance of
Distance
between holes
The holes on the handlebar support are placed at a distance of
Distance
between holes
B
0 0 B
The handlebar supports can be mounted in 4 different positions.
(EXC SIX DAYS)
The handlebar supports can also be mounted at 2 different heights (with and with-
out spacer).
400223-11
Thick spacer
x
(EXC EU, EXC AUS, XC‑W)
0 0 1
1
–
Remove the four screws
bar and lay it to one side.
0 0 2
2
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
400223-10
and take off clamp.
with distance bushing. Remove the start number plate.
M6
15 mm (0.59 in)
3.5 mm (0.138 in)
9 mm (0.35 in)
. Remove the handlebar clamp. Remove the handle-
. Remove the handlebar support.
48
.
with the distance
10 Nm (7.4 lbf ft)
to each other.
from the center.