Adjusting Basic Position Of Clutch Lever; Checking The Fluid Level Of Hydraulic Clutch; Changing The Hydraulic Clutch Fluid - KTM 400 EXC EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adjusting basic position of clutch lever

9.103

Checking the fluid level of hydraulic clutch

9.104
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Info
The fluid level rises with increasing wear of the clutch lining disc.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!

Changing the hydraulic clutch fluid

9.105
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
The fluid level rises with increasing wear of the clutch lining disc.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
screw .

Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
500133-11
Do not make any adjustments while riding!
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top level of container.
» If the level of the fluid does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
400339-10
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt fluid immediately with water.
x
.

with membrane .
 
4 mm (0.16 in)
p. 106)
76