MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the fork protector
9.28
Installing the fork protector
9.29
Removing the lower triple clamp
9.30
(EXC EU, EXC AUS, XC‑W ZA)
–
Fully tighten screw
Guideline
Screw, top triple clamp
–
Fully tighten screw
Guideline
Screw, bottom triple clamp
100023-10
–
Position brake caliper, mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable clip
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screws
.
–
Install the front wheel.
500093-11
x
–
Remove the fork legs. (
–
Remove screws
–
Remove the screws on the right fork leg. Remove the fork protector upwards.
500105-10
x
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
–
Install the fork legs.
500105-10
(EXC SIX DAYS, XC‑W USA)
x
–
Remove the fork legs. (
(XC‑W USA)
–
Dismount the start number plate. (
(EXC SIX DAYS)
–
Remove the headlight mask with the headlight. (
–
Dismount the front fender. (
.
.
M8
.
x
(
p. 64)
p. 42)
on the left fork leg. Remove the fork protector upwards.
M6
M6
x
(
p. 42)
p. 42)
p. 48)
p. 47)
M8
20 Nm
(14.8 lbf ft)
M8
15 Nm
(11.1 lbf ft)
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 47)
43
.