Dismounting The Front Fender; Installing The Front Fender; Removing Headlight Mask With Headlight (Exc, Exc Six Days, Xc-W Za); Refitting The Headlight Mask With The Headlight (Exc, Exc Six Days, Xc-W Za) - KTM 400 EXC EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Dismounting the front fender

9.35

Installing the front fender

9.36
Removing headlight mask with headlight (EXC, EXC SIX DAYS, XC‑W ZA)
9.37
Refitting the headlight mask with the headlight (EXC, EXC SIX DAYS, XC‑W ZA)
9.38
–
Remove screws
–
Make sure that the distance bushings remain in place.
500092-10
–
Ensure that the spacing sleeves are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Take care with the contact between the holding lugs and the start number
plate or headlight mask.
500092-10
–
Switch off all electrical equipment.
–
Remove screw
–
Loosen the rubber band
800018-10
–
Pull out the electric plug connector
headlight.
500156-10
–
Connect the electric plug connector
500156-11
. Remove the front fender.

M6
and take off clamp.

. Push up the headlight mask and swing it forwards.

and remove the headlight mask with the

.

.

10 Nm (7.4 lbf ft)
47