SERVICE WORK ON THE CHASSIS
Greasing the steering head bearing
10.17
Removing the start number plate (XC-W)
10.18
Installing the start number plate (XC-W)
10.19
(EXC SIX DAYS)
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
B00813-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the play of the steering head bearing. (
x
(EXC EU/AUS, XC‑W)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC SIX DAYS)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screw
–
Remove screw
500123-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line. Put on the clamp and mount and tighten screw
500123-11
. Remove screw
.
.
.
.
M8
(
p. 48)
x
x
(
p. 49)
(
p. 48)
x
(
p. 50)
x
and take off the clamp.
. Remove the start number plate.
M6
M20x1.5
12 Nm
(8.9 lbf ft)
M8
17 Nm
(12.5 lbf ft)
17 Nm
Loctite
®
243™
(12.5 lbf ft)
p. 52)
.
10 Nm (7.4 lbf ft)
53
.