08/Mask, Fender; Dismounting The Front Fender; Installing The Front Fender; Removing Headlight Mask With Headlight (Exc-R Eu, Exc-R Aus/Uk, Exc-R Six Days, Exc-R Usa, Xcr-W Za) - KTM 450 EXC-R EU Repair Manual

08/MASK, FENDER

Dismounting the front fender

Installing the front fender

Removing headlight mask with headlight (EXC-R EU, EXC-R AUS/UK, EXC-R SIX DAYS, EXC-R USA, XCR-W ZA)

Refitting the headlight mask with the headlight (EXC-R EU, EXC-R AUS/UK, EXC-R SIX DAYS, EXC-R USA,
XCR-W ZA)
Remove screws
Make sure that the distance bushings remain in place.
500092-10
Check parts for damage and wear. Replace damaged or worn parts.
Make sure that the distance bushings are mounted in the fender.
Position the front fender. Mount and tighten screws
Specification
Remaining screws, chassis
Info
Ensure that there is contact between the holding lugs and the start number
500092-10
plate or headlight mask.
Switch off all electrical equipment.
Remove screw
Loosen the rubber band
500155-10
Pull out the electric plug connector
headlight.
500156-10
Check parts for damage and wear. Replace damaged or worn parts.
Connect the electric plug connector
500156-11
. Remove the front fender.
M6
and take off clamp.
. Push up the headlight mask and swing it forwards.
and remove the headlight mask with the
.
31
.
10 Nm
(7.38 lbf ft)