Assembling The Final Drive Unit Bearings - APRILIA RSV 1000 R FACTORY Workshop Manual

RSV 1000 R - RSV 1000 R FACTORY
5.7.8. ASSEMBLING THE FINAL DRIVE UNIT BEAR-
INGS
If provided:
•
Remove the final drive unit bearings.
Work from the left-hand side:
NOTE Have the appropriate special tool OPT at hand:
- Aprilia part# 8140180 (bearing extractors).
•
Using the appropriate pad, insert the right bearing (6)
completely.
NOTE The right bearing must be inserted until its contact
with the wheel hub shoulder is complete (Y).
•
Insert the inner spacer (5).
•
Use a special pad to insert the left bearing (4).
NOTE The complete insertion of the left bearing (4) will bring
the following components into contact:
- right bearing (6);
- inner spacer (5);
- left bearing (4).
• Insert the elastic ring (3).
NOTE The elastic ring (3) is provided only on the left side of
the final drive unit.
•
Install a new seal (2).
• Insert the left spacer (1) with the longer diameter to-
wards the outside of the vehicle.
Work from the right-hand side:
•
Insert the right spacer (7) with the longer diameter to-
wards the outside of the vehicle.
CYCLE PARTS
5 - 117