RSV 1000 R - RSV 1000 R FACTORY
•
Grasp the damping cylinder assembly (1) and pump it
up and down a dozen of times to expel any air inside.
•
Allow several minutes and measure oil level again. If
necessary, top up or remove oil until oil is at the correct
level (editor's note: 3.35 in).
•
Insert the spacer tube (2).
•
Tighten the top cap (3) on the damping cylinder
assembly until finger tight.
•
Hold the damping cylinder steady with a wrench and
tighten the top cap (3).
•
Use the special tool (A) to tighten the top cap (3) on
the slider.
•
Adjust to obtain correct setting.
CYCLE PARTS
5 - 59