APRILIA RSV 1000 R FACTORY Workshop Manual page 62

GENERAL TECHNICAL INFORMATION
To start the chronometer :
•
press and immediately release the LAP button. The
first time the button is pressed, the stop clock starts.
Pressing LAP again within the first 10 seconds will re-
set the chronometer. Pressing the LAP button again
starts a new lap; the previous lap time and number are
displayed for 10 seconds at the top left of the display.
At the end of the 10 seconds, the chronometer will dis-
play the second lap time and number.
IMPORTANT Up to 40 laps can be stored; pressing the LAP
button after this does not start a new lap and the display will
automatically show the 40 stored lap times. To reset the
chronometer function the 40 stored laps must be reset.
•
To reset a stored time, enable the chronometer.
With the LAP button held down, press the – key for at
least 3 seconds.
•
The display will read "Ø1 LAP ØØ' ØØ" ØØ " to indi-
cate that all 40 stored laps have been set to zero.
•
Stored lap times are zeroed when the battery is dis-
connected from the vehicle.
To display the stored lap times :
•
Enable the chronometer function and hold down
TRIP/V for more than 3 seconds. To scroll through the
laps, press the +/- keys (forwards/back respectively).
• To return to the chronometer function, press TRIP/V
again for more than 3 seconds.
DIAGNOSTICS
Whenever the ignition key is turned to " ", "EFI" is displayed
for 3 seconds.
WARNING
If "EFI" displays together with the warning led
( ) while the engine is running normally, the
ECU has detected a fault.
In most cases the engine will continue to oper-
ate although with reduced performance.
ENGINE OIL PRESSURE
Whenever the ignition key is turned to " ", the engine oil
pressure led turns on for 3 seconds.
WARNING
If the engine oil pressure icon stays on together
with the warning led (
turns on while the engine is running normally,
the engine oil pressure is insufficient.
In this case, stop the engine immediately.
2 - 30
), after starting, or if it
RSV 1000 R - RSV 1000 R FACTORY